EasyManua.ls Logo

Pointer Avionics skyhunter 406 - Page 233

Default Icon
258 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTICE
We~ght and balance or operating limitation changes shall be entered in the appropriate aircraft record. An alteration must be
compatible with all
orevious alterations to assure continued conformity with the applicable airworthiness requirements.
8. Description of Work Accomplished
(If more space is required, attach additional sheets. Identify with aircraft nationality and registration mark and date work completed.)
BELL 412
SN: 36106 N82628
INSTRUCTIONS FOR CONTINUED AIRWORTHINESS
(CONTINUED)
PAGE2
5. MAINTENANCE INSTRUCTIONS: This modification shall be inspected at BHT Scheduled Inspections,
PART A or PART Bas applicable, (ref:
BHT-412-MM below), and Annually 1/A/W:
(a) The scope and detail contained in FAR 43 Appendix D, as applicable to the particular line item(s).
(b) BELL HELICOPTER TEXTRON BELL MAINTENANCE MANUAL
BHT-412-MM Rev.4 (or later
revision), Chap. 5-00-00 INSPECTIONS: (NOTE: aircraft maintenance manuals are available to
each aircraft owner from BELL HELICOPTER TEXTRON).
(c) Manufacturer's publications, as
referer:iced in section 8 of this FAA FORM 337; (NOTE: many
manufacturer's publications ar.e proprietary to the manufacturer and it's approved facilities).
(d) Within the proceeding 12 calender months,the POINTER 3000-10 ELT must be inspected
1/A/W
FAR 91.207
(e) Inspections maintenance and/or repairs are limited to persons authorized by FAR 43, paragraph
43.3, with the approved current publications, and training.
6. TROUBLE SHOOTING: If a failure or malfunction is noted, the wiring in the aircraft may be checked for
proper connections per installation print, as referenced in section 8 of this FAA FORM 337 If no wiring
problems are found, refer to item 5.
7. REMOVAL AND REPLACEMENT: Requires no special instructions due to simple installations using
accepted methods, techniques, and practices,
1/A/W section 8 of this FAA FORM 337, and must be
performed by persons authorized by FAR 43, paragraph 43.3, refer to item 5.
8. DIAGRAMS: N/A
9. SPECIAL INSPECTIONS REQUIREMENTS: N/A
10. APPLICATION OF PROTECTIVE TREATMENTS: N/A
11. DATA: REF: Advisory Circular AC 43.13-18 Chapter 7.
12. LIST OF SPECIAL TOOLS: N/A
13. COMMUTER CATEGORY AIRCRAFT: N/A
14. RECOMMENDED OVERHAUL PERIODS: No additional overhaul time limitations.
15. AIRWORTHINESS LIMITATION SECTION: No additional airworthiness limitations.
16. Revisions: Any revisions or alterations of this ICA must be approved via FAA Form 337 Field Approval
Process.
-END-
D Additional Sheets are Attached

Table of Contents