>--·-~
SkyHuntcrl40~
MANL:INS:SH:X:XX
1. Secure the Master Switch in the OFF position.
Augusta ,2013
Rev25
2. Use a Phillips screwdriver to remove the 8 screws from the front cover that has the
SkyHunter406
TM label on it.(DO NOT REMOVE THE CIRCUIT BOARD COVER OR YOU
WILL VOID ALL WARRANTY)
3. Detach the battery and replace with a new SkyHunter 406
TM battery pack.
4. Replace screws and using a torque screw driver finish tightening the screws evenly to
12 inch pounds.
5. Certified Shop will perform an ELT Self Test to ensure all connections are correct and
ELT is functioning properly.
6. The Pointer Avionics Certified Shop will also need to clear the accumulated battery
use memory inside the EL T. This is performed through the SkyHunter406.com
website. Note: Replacing the battery and NOT resetting the accumulated battery
timer
will not affect the ELT functionality but will affect the indicator LED and the
test results displayed.
7. Ensure that updated battery replacement date is indicated clearly on the ELT using
the battery label provided with the battery pack
8.6 VELCRO STRAPS
Velcro mounting bracket straps are shipped with the replacement battery pack and should be
replaced at this time.
8.7 SHIPPING
Secure the Master Switch in the "OFF" position before shipping, or disconnect the battery pack.
For further inquiries please contact us at WWW.SKYHUNTER406.COM.
8-4
To Next Page
Loading...