11
2.4 I Star ng a cleaning cycle
In order to avoid any risk of injury or material damage, please follow the instruc ons below:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during a shock chlorina on. Wait un l the chlorine level has reached
the recommended value before immersing the cleaner.
• Do not leave the appliance una ended for an extended period.
• Do not use the appliance if the roller shu er is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The ac on in progress
- The cleaning mode selected
- that maintenance is required
• The control box switches to standby a er 5 minutes and the screen and the LEDs are switched o . Press any key to
exit standby mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.4.1 Choice of cleaning mode
• By default, Smart mode is the pre-set cleaning mode (cleaning the oor, walls and waterline over an op mised period
of me depending on the pool's dimensions).
• During the rst cycle launched in Smart mode, the cleaner explores the pool while cleaning for a cycle las ng 2h30.
During this rst cycle, the control box displays "AUTO/2h30" (depending on the model). At the end of this cycle, the
op mum cleaning me is calculated.
• This op mum cleaning me is then saved and becomes the default cleaning me for future cycles launched in Smart
mode. The control box then displays the op mum me calculated.
• To reset Smart mode, press and hold the bu on for 5 seconds. Launch a new cycle in Smart mode so that the
cleaner recalculates the op mum cleaning me.
• The cleaning cycle can be modi ed before the appliance starts or while it is opera ng. The new mode will be started
immediately and the remaining me from the previous cycle will be cancelled.
• Press
:
- Floor only mode:
- Smart mode (Op mised cleaning of the fl oor, walls and waterline):
- Ultra mode (Intensive cleaning of the fl oor, walls and waterline): (depending on the model)
- Waterline only mode: (depending on the model)
• Press
to start the cleaning cycle.
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in oor only mode (a er removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the lter less clogged.
2.4.2 Adjus ng the cleaning me (depending on model)
• You may reduce or increase the me for the cleaning cycle selected or in progress:
-
: Reduce by 15 minutes.
-
: Increase by 15 minutes.
To Next Page
Loading...
Need help?
General
