7
1.3 I Opera ng principle
The cleaner is separate from the ltra on system and can func on independently. It just simply needs to be connected
to the mains power supply.
It nds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: oor, walls, waterline). Debris is sucked in and stored in the cleaner's lter.
The cleaner can be used:
- via the control box supplied with the cleaner,
- or via a smartphone or a tablet compa ble with the iAquaLink™ applica on (see "❸ Using the iAquaLink™ app").
3.5 metres Minimum
: Control box
: Trolley
: Cleaner
: Floa ng cable
: Plug
: Power cord
: Remote control
"iAquaLink™" Wi-Fi
1.4 I Pool prepara on
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following proper es:
Water temperature Between 15°C and 35°C
pH Between 6.8 and 7.6
Free chlorine < 3 mg/ l
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to op mise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
To Next Page
Loading...
Need help?
General
