17
3.4 I Using the app to control the cleaner
Before using the app to control the cleaner, check that:
• Connect the control box to a power outlet,
• Immerse the cleaner in the pool.
3.3.1 Programming and controlling cleaning cycles
From the applica on:
• Start/stop cleaning;
• View the current cycle's remaining cleaning me (displayed in hours and minutes);
• Increase/Reduce the cleaning me by 15-minute sequences (depending on the model);
• Choose the pre-saved cleaning modes
• The new cleaning mode will take e ect for the cleaning cycle in progress and all future cycles.
• The cleaning cycle me may vary depending on the selected se ngs.
• Schedule cleaning cycles (days and hours) (depending on model); Cleaning cycles may be programmed to repeat,
only one program can be set per day;
• Check the pool's temperature during the cleaning cycle (depending on model);
The cleaner measures the water temperature while opera ng.
• When the cleaner is at the bo om of the pool, it is normal for there to be a temperature di erence
between that measured by the cleaner and that measured by a thermometer placed at the pool's surface
or measured by another appliance.
3.3.2 "Li System" func on for helping to remove the cleaner from the water
• Only ac vate the Li System func on if the cleaner is in view.
• From the applica on, press to use the Li System func on (see "2.5.1 Automa c "LIFT SYSTEM" mode").
• Press the arrows to rotate the cleaner le or right.
• When the cleaner is facing the right wall, press the bu on to bring the cleaner to the wall.
3.3.3 Remote control (depending on the model)
The cleaner can be controlled using your smartphone or tablet as a remote control.
• Use the remote control only if you have the cleaner within view.
• 2 modes are available for pilo ng the cleaner (depending on the equipment):
"Joys ck mode": Press the icons to move the cleaner forwards and backwards and to turn le or right.
"Kine c mode": Control the cleaner by l ng the mobile device upwards (backwards movement), downwards
(forward movement), to the le (turn le ), to the right (turn right).
• For localised cleaning, use the "Localised cleaning" func on (depending on the model): when this func on is
ac vated, the cleaner cleans a 1m
2
area in front of it.
• If the cleaner is rela vely slow to respond to an ac on requested in the app, check the Wi-Fi network
signal, see "3.2 I First- me cleaner con gura on".
To Next Page
Need help?
General
