Polaris W Series - Removing the Cleaner from the Pool

12
2.5 I Removing the cleaner from the water
• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.5.1 Automa c "LIFT SYSTEM" mode
The "Li System" func on was designed to facilitate removing the cleaner from the water. It may be ac vated at any
 me, during or at the end of a cleaning cycle.
• If necessary, point the cleaner at the desired wall by pressing and holding the bu on, the cleaner pivots.
When facing the right wall, release the bu on. The cleaner moves towards the wall (see  gure ).
• Or simply press and release the
When facing the right wall, release the bu on. The cleaner moves towards the wall
bu on to move the cleaner forwards towards the wall in front of it (see
 gure ).
• It climbs the wall and stays at the waterline (see  gure ).
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see  gure ).
00'60''
2.5.2 Manually
• Switch o the appliance by pressing .
• Bring the cleaner to the edge of the pool by gently pulling on the  oa ng cable.
• When possible, pick up the cleaner by the handle and li it gently out of the pool so that the water it contains drains
into the pool (see  gure and ).
EN