For first use, charge the remote and spare battery for a minimum of 1 hour. Place the remote and
spare battery in the base.
ANC
Timer
Custom Button
Headphones
Camera
Headset
Lock
General
Indicator Light
ANC
Scaled to 45% of full size
Lock
General
Indicator Light
Music
Scaled to 45% of full size
The base charge LEDs flash orange when charging and turn solid green when fully charged. Allow
4 hours for full charge.
Swap batteries regularly
A fully-charged battery powers your remote for up to 10 hours, however, we recommend swapping
batteries approximately every 4 hours.
IMPORTANT Swapping batteries every 4 hours maximizes the battery life and ensures
communications are not interrupted by low batteries.
Charge remote and spare battery when not in use
Place the remote and spare battery in their charging wells between battery swaps or when not in
use.
Low battery warning
Recharge your battery if you hear a single beep every 10 seconds.
Remove battery for storage
Remove battery from remote when storing to prevent the battery from depleting.
Replace batteries
Monitor the performance of your batteries for gradually decreasing talk times and replace as
needed.
NOTE Rechargeable batteries of all types gradually age and lose their ability to give and receive
charge. Replace your rechargeable batteries after 3 years or 300 charge cycles, whichever comes first.
CAUTION Touching the battery-charging contacts or placing objects other than the batteries and
remote in the charging wells may adversely affect the operation of the device.
Charge
Charge your remote
Manage batteries
13
To Next Page
Loading...
