Power your remote with a charged battery pack.
1 Slide battery pack onto the remote and snap into place without force.
2 Remote's Audio Link LED flashes when ready for use.
Press the Push-to-Talk (PTT) button on the remote to key up your radio. The Talk LED on the base
turns green.
Locking operation
1 Align the selector vertically to the remote's center-line.
2 Depress the PTT button and slide it down toward the selector until the button locks into place in
the ON position.
Momentary operation
Turn the selector horizontally from the locking position. The PTT button will default to the OFF
position when released.
Place a test softphone call and adjust softphone volume and PC sound volume accordingly.
A triple beep warns you if your remote is out of range and has lost its audio link with the base.
System basics
Power remote
Key up radio
Adjust headset
microphone volume
(softphone)
Stay within range of your
base
14
To Next Page
Loading...
Need help?
General
