Using the diagrams below, choose the appropriate connection for your system.
IMPORTANT Only 1 connection can be active and plugged into the base at a time. If you choose to
switch connection type, unplug and re-insert the power cable to establish a new connection.
Connect your system with the console interface cable.
NOTE Base configuration settings
Talk output
Talk Setting (on bottom of base)
Dynamic 1
Electret 2, 3
Carbon 4 (default; correct in most cases)
Connect your system with the USB cable.
Connect your system
Analog
USB (USB variant only)
8
To Next Page
Loading...
Need help?
General
