Getting Started with Your Phone
1 - 3
Connecting Network and Power Sources
There are two ways to connect your phone to the network and a power source.
Your system administrator can tell you which of the following methods best
suits your teleconferencing needs:
• Power over Ethernet (PoE)
• AC Power
Power over Ethernet
Power over Ethernet is the default connection for your phone.
The following figure shows how to connect your phone to the network using
a PoE source.
To connect the phone using PoE:
1. Connect one end of the 25-foot Network Cable to the LAN jack on the
phone.
2. Connect the other end of the 25-foot Network Cable to an available LAN
port on the wall or hub/switch device port.
Note
AC power adapters are not included in the PoE package. If you require one, see
your system administrator.
2
1
25-foot Network Cable