110-392 33
Certificate of Compliance
All Chillers are tested after assembly to ensure that the product meets or exceeds published mechanical and
safety specifications as well as your satisfaction. The Certificate of Compliance is included with the Chiller. The
following graph explains the steps involved in a typical test.
0.00
5.00
10.00
15.00
20.00
25.00
30.00
35.00
40.00
0:00:00
0:04:04 0:08:09 0:12:40 0:16:45 0:20:50 0:24:55
0:29:00 0:33:0
1. Raise fluid temperature.
2. Measure cooling performance.
3. Apply heat load to Chiller to simulate real application conditions. The heat load applied is based on the Chiller’s
cooling capacity.
4. Measure temperature stability.
Equipment Disposal (WEEE Directive)
or
This equipment is marked with the crossed out wheeled bin symbol to indicate it is covered by the Waste
Electrical and Electronic Equipment (WEEE) Directive and is not to be disposed of as unsorted municipal waste.
Any products marked with this symbol must be collected separately, according to the regulatory
guidelines in your area.
Service and Technical Support
If your unit fails to operate properly, contact the supplier from whom the unit was purchased. Have the model,
serial number, and voltage information from the back panel label along with a summary of the problem available.
1
2
3 4
To Next Page
Loading...
Need help?
General
