PolyScience DuraChill 58 Series - Electrical Diagram - 208-230 V and 380-460 V; 3 PH; 50-60 Hz Models with Heater Option

46 pages

To Next Page

To Previous Page

110-392 41

Electrical Diagram – 208-230V and 380-460V / 3PH / 50-60Hz Models with heater option

Main Page

Default Chapter3
- Table of Contents3
Introduction5
- General Safety Information5
- Safety Recommendations5
- Regulatory and Compliance Testing7
- Contents7
  - Controls and Components8
Quick Start10
Installation and Startup11
- Site Requirements11
- External Piping12
- Process Coolant14
- Electrical Power15
  - Phase Requirements (if Applicable)15
- Optional Signal Inputs/Outputs15
- Startup16
Normal Operation17
- Selecting the Temperature Unit17
- Displaying and Adjusting the Set Point17
- Selecting the Internal / External Temperature Display17
- Displaying and Adjusting the Ambient Tracking Offset18
- Displaying and Adjusting the Remote Control Temperature18
- Selecting the Pressure / Flow Rate Display and Units18
- Setting Operational Parameters / Limits19
Display, Alarm and Error Messages22
Adjusting the High Pressure Bypass Setting24
Enabling / Disabling the Local Lockout24
Over-Temperature Protection25
Routine Maintenance26
- Condenser, Air Vents and Reusable Filter26
- Inline Strainer26
- Fluid Level26
- Cleaning26
Temperature Calibration27
- Internal Calibration Offset (C1)27
- External Calibration Offset (C2)27
Flow Rate Calibration (Fc)28
Fuse Bits (Fb)28
Troubleshooting29
- Diagnostic Mode30
Technical Information31
- Controller Specifications31
- Performance Specifications31
- Electrical Specifications32
- Pump Performance33
RS-232 / RS-485 Communications34
Certificate of Compliance35
Equipment Disposal (WEEE Directive)35
Service and Technical Support35
Replacement Parts36
- Pumps37
Warranty38
Appendix39
- Flow Schematic - All Models39
- Electrical Diagram - 208-230V / 1PH / 50-60Hz Models Without Heater Option40
- Electrical Diagram - 208-230V / 1PH / 50-60Hz Models with Heater Option41
- Electrical Diagram - 208-230V and 380-460V / 3PH / 50-60Hz Models Without Heater Option42
- Electrical Diagram - 208-230V and 380-460V / 3PH / 50-60Hz Models with Heater Option43
- Options44

PolyScience DuraChill 58 Series - Electrical Diagram - 208-230 V and 380-460 V; 3 PH; 50-60 Hz Models with Heater Option

Table of Contents

Related product manuals