PolyScience DuraChill 58 Series User Manual

Name: PolyScience DuraChill 58 Series
Brand: PolyScience
Rating: 5 (1 reviews)

46 pages

To Next Page

To Previous Page

110-392 42

Options

General Options Wiring

Status Alarm (STA): Relay is energized when Chiller is running normally. Relay is de-energized when a fault condition

is detected or the unit is placed in Standby.

Remote ON/OFF: RCV = Chiller turns OFF when 12-24V AC or DC signal is applied.

RCS = Chillers turns OFF when contacts are closed.

RS-485 Communications Wiring

Default Chapter3
- Table of Contents3
Introduction5
- General Safety Information5
- Safety Recommendations5
- Regulatory and Compliance Testing7
- Contents7
  - Controls and Components8
Quick Start10
Installation and Startup11
- Site Requirements11
- External Piping12
- Process Coolant14
- Electrical Power15
  - Phase Requirements (if Applicable)15
- Optional Signal Inputs/Outputs15
- Startup16
Normal Operation17
- Selecting the Temperature Unit17
- Displaying and Adjusting the Set Point17
- Selecting the Internal / External Temperature Display17
- Displaying and Adjusting the Ambient Tracking Offset18
- Displaying and Adjusting the Remote Control Temperature18
- Selecting the Pressure / Flow Rate Display and Units18
- Setting Operational Parameters / Limits19
Display, Alarm and Error Messages22
Adjusting the High Pressure Bypass Setting24
Enabling / Disabling the Local Lockout24
Over-Temperature Protection25
Routine Maintenance26
- Condenser, Air Vents and Reusable Filter26
- Inline Strainer26
- Fluid Level26
- Cleaning26
Temperature Calibration27
- Internal Calibration Offset (C1)27
- External Calibration Offset (C2)27
Flow Rate Calibration (Fc)28
Fuse Bits (Fb)28
Troubleshooting29
- Diagnostic Mode30
Technical Information31
- Controller Specifications31
- Performance Specifications31
- Electrical Specifications32
- Pump Performance33
RS-232 / RS-485 Communications34
Certificate of Compliance35
Equipment Disposal (WEEE Directive)35
Service and Technical Support35
Replacement Parts36
- Pumps37
Warranty38
Appendix39
- Flow Schematic - All Models39
- Electrical Diagram - 208-230V / 1PH / 50-60Hz Models Without Heater Option40
- Electrical Diagram - 208-230V / 1PH / 50-60Hz Models with Heater Option41
- Electrical Diagram - 208-230V and 380-460V / 3PH / 50-60Hz Models Without Heater Option42
- Electrical Diagram - 208-230V and 380-460V / 3PH / 50-60Hz Models with Heater Option43
- Options44

Questions and Answers:

Need help?

Do you have a question about the PolyScience DuraChill 58 Series and is the answer not in the manual?

PolyScience DuraChill 58 Series Specifications

General

Brand	PolyScience
Model	DuraChill 58 Series
Category	Laboratory Equipment
Language	English

Related product manuals

PolyScience DuraChill 58 Series User Manual

Table of Contents

Questions and Answers:

PolyScience DuraChill 58 Series Specifications

Related product manuals