19
Installing Webster Software in Windows
Installation in Windows requires “Administrative Privileges.” To
install Webster software in Windows:
1 Turn on your computer and wait for Windows to start. For best
results, make sure no applications are running.
2 Place the Webster software CD in your CD-ROM drive. The setup
program starts. If the setup program does not start, open
Windows Explorer and double-click “Setup.exe” on the CD.
3 Follow the prompts to install the software.
The setup program detects the COM port to which your white-
board is attached. To manually identify the COM port, see
“Establishing Communication between the Board and Com-
puter” on page 20.
If your computer is permanently connected to an IRP or IPD sys-
tem, we recommend that you check the “Run Webster at Star-
tup” option during installation.
4 Restart, if prompted.
Installing Webster Software on a Macintosh
To install Webster software on a Macintosh:
1 On the Macintosh, place the Webster software CD in your
CD-ROM drive.
2 Double-click the Webster installer icon on the CD.
3 Follow the prompts to accept the license agreement and install
the software.
note:NOTE:
Under OS 8.6 or OS 9, you may need to install QuickTime 5 (provided
on the Webster installation CD) or above in order to support the
graphic import/export features described in this manual. Make sure
you use the “Recommended Install” option for QuickTime.
Webster_draft2.book.mif Page 19 Friday, October 11, 2002 10:07 AM
To Next Page
Loading...