25
note:NOTE:
Webster TS models: The whiteboard's surface can be damaged by
sharp objects, such as ballpoint pens and rulers. Scratches can
cause permanent ink stains and data loss due to electrical
malfunctions.
To write:
1 Choose a pen (TS and LT models) or stylus (IRP and IPD models).
2 Select a pen color on the whiteboard icon strip (TS models) or in
the projection toolbar (IRP and IPD models). The software
records your writing in the color you choose.
3 Use firm consistent pressure as you write.
note:NOTE:
Webster TS models: As you write, the whiteboard provides audible
feedback, and the green LED glows brighter to indicate that it
recognizes your strokes.
Erasing the Board
Erase functions are based on a calculated circle around a single
point. Always use the erasers that are provided with the Webster
board. Erasing depends upon which Webster model you use.
To erase on Webster TS models:
• Large areas: Tap the Wide Erase icon on the board. Use the
eraser felt flat against the whiteboard.
• Small areas: Tap the Narrow Erase icon on the board and erase
with your finger or the edge of the round eraser.
To erase on Webster LT models:
• Use the large or small eraser with the felt flat against the white-
board. Do not cover the reflective strip around the perimeter of
the eraser. Never use the narrow edge of the eraser on the
whiteboard.
Webster_draft2.book.mif Page 25 Friday, October 11, 2002 10:07 AM
To Next Page
Loading...