24
Webster Basics
When the Webster software is running on a computer connected to
the board, anything you write or draw on the board is also displayed
on the computer.
How Webster Works
To use Webster:
1 Make sure the board is plugged in and turned on, if necessary.
2 On the computer connected to the whiteboard, start the Webster
application. If the Webster software is not installed on the
computer, or if the software does not automatically detect the
whiteboard, refer to “Installing Webster Software” on page 18.
3 Choose a pen.
4 Write or draw on the board. Your work appears in the Webster
software window. Refer to “Writing on the Board” on page 24.
5 To erase, choose an eraser tool and erase. Refer to “Erasing the
Board” on page 25.
6 To print the contents of the board on a printer connected to the
computer, tap the Print icon. Refer to “Printing the Board” on
page 26.
7 To capture a copy of the board in the software, tap the Snapshot
icon. Refer to “Capturing a Snapshot of the Board” on page 26.
Writing on the Board
The whiteboard sends writing data to your computer by detecting a
single point of pressure or of reflected light. Whenever you write on
the whiteboard, make sure there is only one point of contact at a
time.
note:NOTE:
Use only the recommended markers, stylus, and erasers.
Webster_draft2.book.mif Page 24 Friday, October 11, 2002 10:07 AM
To Next Page
Loading...