POOLEX 90 - Heating Mode (Inverter)

20
When the incoming water temperature is less than or equal to the required temperature (setpoint tempera-
ture - 1°C), the heat pump will switch to heating mode. The compressor will stop when the temperature of
the incoming water is greater than or equal to the required temperature (setpoint temperature + 1°C).
Step 1: Long press 3s to switch on your pump.
Step 2: Long press 3s to switch from one mode to another until the Heating Mode is displayed.
Step 3: Using buttons and select the required temperature (15-40°C).
4. Use
4.3 Heating Mode (inverter)
WARNING: Before starting, ensure that the ltration pump is operating correctly.
WARNING: When the cooling mode switches to heating mode or vice-versa, the heat pump will restart
after 10 minutes.
EXAMPLE:
If you have selected 28°C, your screen will display:
Once the symbol stops
blinking, the required temperature
is validated and is replaced by the
water’s current temperature (25°
in our example).
Required
temperature“Blinking”
Current water
temperature
Current temperature
of the ambient air
Useful information