poolstar POOLEX - Pairing the heat pump

EN | 23
EN
Step 1: Now start the pairing.
Choose your home WiFi network, enter the WiFi password and press
“Conrm”.
WARNING: The «Smart Life» applicaon only supports 2.4Ghz
WiFi networks.
If your WiFi network uses the 5GHz frequency, go to the interface of
your home WiFi network to create a second 2.4GHz WiFi network
(available for most Internet boxes, routers and WiFi access points).
Congratulations, your heat pump can now be controlled from your smartphone.
4. USE
Step 2: Activate the pairing mode on your heat pump according to the
following procedure.
When the heat pump is turned on, press UP + MODE for 3s to start the
WiFi pairing. The WiFi logo ashes.
Check that WiFi is enabled on your smartphone.
The pairing is successful, the "WiFi" logo remains xed, you can rename
your Poolex heat pump then press “Done”.
Pairing the heat pump