Possl Globecar Summit - Entrance Step Operation and Safety

21Motorcaravan - 09/21-0 - GLO-MJ22-00EN
Before the journey
4
4.2 Entrance step
4.2.1 Electrically operated entrance step
Operating switch The switch to operate the entrance step is located on the inside of the vehicle
in the area of the conversion door.
Extending:
 Press the rocker switch (Fig. 1,1) down until the entrance step has
extended completely.
Retracting:
 Press the rocker switch (Fig. 1,1) up until the entrance step has retracted
completely.
Fuses The fuse for the entrance step is located at the entry of the sliding door (on the
right behind the light in the entry area). In the case of a malfunction of the ent-
rance step the light can be levered out with a suitable tool and subsequently
the fuse replaced.
 Before starting the journey and also after short breaks check whether the
entrance step has been retracted completely.
 Do not stand in the direct range of movement of the entrance step while
the entrance step is being extended or retracted.
 Do not step on the entrance step until it has extended completely. There
is a risk of injury!
 Never raise or lower persons or loads with the entrance step.
 Clean dust and dirt regularly from the entrance step, do not grease or oil
moving parts.
Fig. 1 Operating switchentrance step
Fig. 2 Entry light living area Fig. 3 Fuse entrance step (20 A)