What to do if my Postek Label Maker is sending data but not printing?
If data is being sent but the printer isn't printing, ensure the correct driver is chosen in the label software and reset the printer.
Why does only the READY LED blink on my Postek Label Maker?
If only the READY LED is blinking, it may indicate a serial I/O error, so check the baud rate settings. It could also mean a memory overflow, in which case you should restart the printer or reset the printer.
Essential safety guidelines for operating and handling the printer to prevent injury or damage.
Detailed technical specifications for the G-2108/G-3106 barcode label printer.
Specifications for the power adapter and a list of items included in the printer package.
Steps for initial printer setup and identification of main parts and structures.
Guidance on connecting the printer to a host and available interface types (RS232, USB, Ethernet).
Step-by-step instructions for properly loading the thermal transfer ribbon.
Procedures for loading media rolls in Standard, Peel-off, and Cutting modes.
How to adjust the media sensor for accurate label detection in different modes.
Covers power switch, front panel, and LED indicators for printer status and control.
Explains the functions of the printer's physical buttons for various operations.
Details advanced operations like media sensor calibration and mode changes.
Describes how to perform a self-test and what information is printed.
Procedure for resetting printer settings to factory defaults.
Information on installing the printer driver and label editing software.
Important warnings before performing any maintenance procedures on the printer.
Detailed instructions for cleaning the printer's printhead to ensure longevity.
Steps to clean the platen roller, which supports labels as they feed out.
Guidelines for cleaning dust and debris from the printer's internal components.
Explains LED blinking patterns and their corresponding error causes and solutions.
Addresses issues like vertical lines, timeout errors, data transmission, and jams.
Tips for improving print quality, including driver settings and consumables.
Procedures for clearing alarms or restarting the printer to resume printing automatically.
Details the DB9F connector pin assignments and connection configurations for RS232.
Describes the 36-pin Centronics interface pin assignments and data transmission.
Provides a reference table for ASCII character codes used by the printer.
General| Brand | Postek |
|---|---|
| Model | G-2108 |
| Category | Label Maker |
| Language | English |
To Next Page
