5. Remote Controller
4.7.3 Image Storage
The videos and pictures recorded by Atom SE will be stored in SD card, instead of App or user’s
album. Make sure to insert SD card prior to flight. Otherwise, it is unable to record and shoot.
(SD card is not included in the product’s pack list!)
User can preview and download the videos and pictures (the drone and the remote controller
should be connected) in App.
SD Card Requirements
File format: FAT32, exFAT
Capacity: 4G-256G
Speed requirements: It is suggested to use SD card above U1 (UHS Speed Class 1) or C10
(Class 10)
The video downloaded from App is just 720P resolution used in video transmission. Please read SD
card with computer or other device in order to acquire videos of higher definition.
The recording can be terminated due to slow write-in when using the U1/C10 SD cards of certain
brands.
If important data are stored in your SD card, please backup them properly.
Do not insert or unplug the SD card when the product is powered on. It may lead to data damage or
loss, or even SD card damage when inserting or unplugging SD card during video recording.
Potensic does not bear responsibility for any loss due to user’s misoperation of SD card.
5.1 Overview
Potensic Atom SE is equipped with the DSRC02A Remote controller, which boasts Potensic
long-range PixSync 2.0™ image transmission technology, offering a maximum transmission
range of 4km/13,123ft and 720p when displaying video from the drone to PotensicPro on your
mobile device. Easily control the drone and camera using the onboard buttons. The detachable
control sticks make the remote controller easier to store. Thanks to the 2.4Ghz dual band
antenna, in a wide-open area with no electromagnetic interference, PixSync 2.0™ smoothly
transmits video feed at up to 720p at a max altitude of 120m.
The built-in battery has a capacity of 3000mAh and a maximum run time of 2.3 hours. There is a
USB C port for device connection. The remote controller charges the mobile device with a
charging ability of 500mA@5V.
15
When used with different drone hardware configurations, the remote controller will automatically
select the corresponding firmware version for updating and support the following transmission
technologies enabled by the hardware performance of the connected drone models:
a. Atom SE: PixSync 2.0™ b. Atom: PixSync 3.0™
To Next Page
Loading...
