(955) 9700-GB WARTUNG
GB
- 18 -
MainTEnanCE anD sErViCE
General maintenance advice
In order to keep the implement in good condition even after a long
service life, please observe the following points:
- After the first hours of operation retighten all screws.
During the operating season
- Check all screws occasionally and retighten if necessary.
- Grease the four greasing points on both of the swing bolts
weekly.
- Grease all other greasing points at least twice per season.
At the same time oil joints and adjusting spindles also.
Expendable parts
- Replace worn out expendable parts in time to prevent all stress-
bearing parts from becoming damaged.
Tyre pressure
- Pay attention to the correct tyre pressure!
Check tyre pressure regularly!
• Danger of bursting exist when inflating or when tyre
pressure is too great!
Cleaning the machine parts
Take note!
Do not use a high pressure cleaner to clean bearings or hydraulic
parts.
- Danger of rust formation!
- Lubricate the machine after cleaning and carry out a short trial
run.
- Cleaning with too much pressure can damage the paintwork.
Parking in the open
When parking in the open for
longer periods, clean plunger
rods and then grease.
Winter storage
- Thoroughly clean the machine
before storing.
- Store the machine where it is
weather protected.
- Protect exposed parts against rusting.
- Grease all greasing points
Hydraulic unit
- Check hydraulic hoses regularly for damage.
Immediately replace porous or damaged hydraulic hoses.
Beware: Danger of infection!
• Where there are dfects in the hydraulic unit, do not
touch areas of leakage.
Before working on the hydraulic unit
- lower implement to the ground.
- When carrying out maintenance work on a raised implement always
make it secure with a suitable support.
- Depressurize the hydraulic unit and turn the motor off.
To Next Page