Power Electronics SD700 Series Getting Started Manual

POWER ELECTRONICS
SD700 – TOUCH-GRAPHIC DISPLAY
APPLICATION MANAGEMENT
29
E
NGLISH
2.5.2. Unlock Parameters
In order to unlock parameters, it is necessary that they are locked. Then, the user should follow
the next steps:
1. Access to the configuration parameter ‘G1.1 Î Lock parameters’ in group ‘G1 Options’. For
this, tap on ‘G Configuration group’ menu in the initial screen firstly, and then, tap on group
‘G1 Options’. See the full navigation tree in the figure below.
2. Tap on the value cell of the parameter ‘G1.1 Î Lock parameters’. A dialogue window of
parameter configuration will appear with the available configuration options.
3. Tap on option ‘NO’, and then, tap on ‘OK’ button. The dialogue window of password
configuration will appear. This dialogue window shows the minimum and maximum allowed
values for the password.
4. Introduce the password number registered when parameters were locked and tap on ‘OK’
button. The dialogue window will be closed and the parameter is updated. Now, the
parameters lock is deactivated. In this way, all of the configuration parameters are unlocked
and the user can modify them.
The following figure shows the full navigation tree to unlock parameters.
Figure 2.16 Parameters unlock. Navigation tree

Power Electronics SD700 Series Specifications

General

Brand	Power Electronics
Model	SD700 Series
Category	Inverter
Language	English