powersoft DigiMod PFC2 - Page 22

22
DigiMod PFC2 - PFC4 | SERVICE MANUAL
INDEX
DigiMod PFC4DigiMod PFC2
The pushbuttons must be
set to the pressed position.
+ ++ +++
122Vp 1KHz 122Vp 1KHz
CH1/2 CH1/2
CH3/4
Connect the module to the KT000291 Interface Board (CH1/2 on DigiMod PFC2, CH1/2 - CH3/4 on DigiMod PFC4) , and press the
switches between the XLR connectors in order to link CH1+CH2 and CH3+CH4.
Connect a function generator to the CH1, CH2 (PFC2) or CH1, CH2, CH3, CH4 (PFC4) ins on the Interface Board and feed a 1 kHz sine
wave @ 1 Vrms 8-32 EIAJ test signal.