9
DigiMod PFC2 - PFC4 | SERVICE MANUAL
INDEX
DigiMod PFC4
Checking the Power Supply
Ω
Ω
15Vdc 27.5mA
(Fig. 9)
By means of a multimeter set to Ohm, check for any short
circuit in the Mosfets by probing on the points indicated
on (Fig. 9).
This step is common to both PFC2 and PFC4 models.
By means of the CB000591.R, connect a DC Power supply
to the module’s PL1 connector.
Supply 15Vdc.
Check the current drawn by the module, it should be
around 27.5mA.
(Fig. 10)
(Fig. 10)
Model Kit Number Description
DigiMod PFC2
KT000890.R KIT DM PFC2 PSU
DigiMod PFC4
KT000843.R KIT DM PFC4 PSU
Please refer to the following table when ordering the
repair Kit.
Please refer to the following table when ordering the
repair Kit.
Model Kit Number Description
DigiMod PFC2
KT000891.R KIT DM PFC2 AMP 1CH
DigiMod PFC4
KT000841.R KIT DM PFC4 AMP 1CH
To Next Page
Loading...
