powersoft K2 User Manual

LEDs and display menu | 13
Display
Local presets
Setup
Menu
Settings
Amplier Settings
DSP Settings
1
Network Settings
2
Output meters
Temperature
Mains meters
Amplier name
Lock presets
Locked bank size
Recall local preset
Save local preset
Change lock code
Erase all presets
Hardware Info
Hardware Monitor
LCD contrast
Set Keylock code
Service
Source selection
Source mode
Gain trim
If no link
AES3-XLR rear panel
AES3-A
AES3-B
Parallel from L
Parallel from R
Stereo
Mute
Analog
Display Amp data
Edit Amplier name
Analog  Out
Analog  DSP  Out
1
AES3  Out
1
AES3  DSP  Out
1
KAESOP  Out
2
KAESOP  DSP  Out
1, 2
Output attenuation
Input gain/sens
Inuput select
Max output voltage
Max mains current
Clip limiter CH1
Clip limiter CH2
Gate CH1
Gate CH2
Mute at Power on
Idle Mode
see “DSP Settings” diagram
Device mode
Addressing mode
Set address
Show net cong
Audio
Repeat (default)
Forward to AES3-A
Forward to AES3-B
Forward to both
IP address
subnet mask
Default gateway
1
Available only with optional KDSP board
2
Available only with optional KAESOP board
FIGURE 20: Main menu diagram.

powersoft K2 Specifications

General

Brand	powersoft
Model	K2
Category	Amplifier
Language	English