powersoft K2 User Manual

Software
16
16 : 1.Armonía Pro Audio Suite
Armonía Pro Audio Suite™ has been specically de-
signed to be used with K Series ampliers as an easy to
use conguring interface that allows system setting and
customization.
Communication between the software and the ampli-
er is established via an RS-485 or Ethernet connection,
depending on the available ports on the units.
Armonía provides control and monitoring of a wide range
of amplier functions, such as attenuation, mute, internal
temperature and voltage rail monitoring.
On K Series equiped with the KDSP board Armonía of-
fers full control on all signal processing features, including
input and output equalization, alignment delays, FIR lters
and load impedance monitoring, etc.
Armonía is scalable: it allows control of a single
Powersoft amplier or a very large system containing many
ampliers. For large xed or touring installations, Armonía
gives the operator the ability to monitor and control all am-
pliers in the system from a single location, regardless of
the ampliers’ positions.
daisy-chaining. A looped Ethernet topology is also per-
missible, which will provide redundancy in the event of a
network failure.
An amplier system using an RS-485 network can
either be daisy-chained throughout or use the Powersoft
PowerHub as a local switch.
16 : 2 .Third party software
The K Series provides plug-ins for different third party
control software.
Developed for Powersoft by independent consultants
specialized in systems integration designs, these plug-ins
provide monitoring and control of K Series ampliers when
integrated in proprietary network environment, such as:
 Q-Sys™: it provides integrated monitoring and control
of Powersoft K Series and Duecanali Series ampliers
through a QSC Q-Sys system.
 Crestron
®
macros: it provides integrated monitoring
and control of Powersoft ampliers through a Crestron
control system. These macros allow you to expand
the exibility of Powersoft’s products in audio video
integrated Systems.
 AMX
®
module: it provides AV system integrators with
an interface control solution to take full advantage of
the performance and exibility of Powersoft’s products
in xed install applications.
 MediaMatrix
®
NWare™: it provides integrated moni-
toring and control of Powersoft K Series.
Powersoft’s Armonía Pro Audio Suite™ software will be
required for initial setup and management of the ampliers.
Further information is available on the software section
of Powersoft website www.powersoft-audio.com.
This software has been designed to accept software
plug-ins to enable third-party product control.
Armonía is freely available on Powersoft website: it can
be downloaded after signing up for the user forum: further
information is available on the software section of Powersoft
website www.powersoft-audio.com.
16 : 1.1. Networking
Powersoft ampliers can connect to a PC running
Armonía in two ways: with an RS-485 serial connection or
via Ethernet.
Systems employing both categories of ampliers may
use both methods simultaneously: an Ethernet network be-
ing implemented for some ampliers, and RS-485 for the
others (bear in mind that Ethernet is a faster communica-
tions protocol than serial RS-485).
The range of network topologies which can be used in
wiring a real system varies between the two communica-
tions methods.
Ethernet provides a slightly greater degree of freedom,
as standard IT network switches may be used to create
multiple hub systems as well as a single hub and linear
36 | K Series | User guide

powersoft K2 Specifications

General

Brand	powersoft
Model	K2
Category	Amplifier
Language	English