10
2.3 Change Views
Change your view of the model by moving, rotating, scaling the view, and so on.
2.3.1 Move
You can move the view of printing frame in the software interface using the following three methods:
A. Press and hold the left button of the mouse and then drag the cursor.
B. Press and hold the middle button of mouse and then drag the cursor.
C. Hold the Shift key while pressing the right button of the mouse and then drag the cursor.
2.3.2 Rotate
You can rotate the view of printing frame in the software interface using the following two methods:
A. Hold the right button of the mouse and then drag the cursor.
B. Hold the Shift key while pressing the left button of the mouse and then drag the cursor.
2.3.3 Scale
You can scale the view of printing frame in the software interface by scrolling the mouse wheel in any
condition.
2.3.4 Set
You can set the view of printing frame in the software interface to observe the model from six angels by the
following two methods (Top/Bottom/Front/Back/Left/Right View):
A. Click the View menu, and then select the view to use to observe the model.
B. Click the Look button on the left of the software interface, and then select the view you require.
2.3.5 Reset
A. Click the View menu and then select Home view to reset the view.
B. Click the Look button on the left of the software interface, and then click Reset button to reset it.
2.3.6 Show Model Outline
Click the View -> Show Model Outline, it will highlight the outer surfaces of your model file with gray and
white color.
2.3.7 Show Steep Overhang
Click the View -> Show Steep Overhang menu. When the intersection angle between the model surface and
horizontal line is within the overhang threshold value, where the surface has a steep overhang and it is
highlighted red in the software. Overhang threshold value can be set as needed. The default value is 45
degree.
2.4 Edit Models
You can edit the models by moving, rotating, scaling the model and so on.
2.4.1 Move
When the model is selected, you can change the model location on the build platform using the following
two methods:
A. Click the Move button on the left of the software interface. Holding the left button of the mouse and then
drag the cursor to adjust the location of the model in the XY direction. Hold the shift key and while pressing
the left button of the mouse, drag the cursor to adjust the location of the model in the Z direction. You can
see the distance and direction of the movement which refers to the relative distance between present and
former locations.
B. Click the Move button on the left of the software interface and then enter the distance value you want to
move on the X/Y/Z axes positioning. Click Reset button to reset distance values.
To Next Page
Loading...