■ 5 Operation
38
5.5.2 The print key
– Ensure that there is no drying taking place, i.e. that the instrument
is in weighing mode.
• Printing out an individual value or a report
– Press «PRINT» briefly.
– The drying report is printed out. The report for the last
measurement can be printed out at the start of a new drying
procedure. Reports printed afterwards do not contain any interim
results. It is otherwise identical to the drying report which is
printed during the measurement. If no drying has been performed
since the instrument was started up, the weight value is printed.
• Printing out the statistics
– Keep «PRINT» pressed until "PRINT STATISTICS" is displayed
– Release «PRINT»
– Statisics are printed.
• Printing the instrument settings
– Keep «PRINT» pressed until "PRINT STATUS" is displayed.
– Release «PRINT». The instrument settings are printed.
Status :
--------
Status printout for the settings.
Date 07.10.2018 Time 16:12:39
Name : XM 50
Heater : Halogen / 50Hz
Software : C00-0000 P19
Serialno : 4100283
Instrument identification
Print :
Printformat :
Date and Time : on
Balance-ID : on
Method-ID : off
Counter : on
Dryer Setup : on
Print rate : off
Operator-ID : off
Cal. Info : on
Print rate : 1.0 Min
Operator : SAMPLE
Mode : Printer
Report printout settings
Calibration :
Mode : external
Defined weight : 0.0000 g
Balance calibration settings
Temp. cal. : off
Temperature calibration settings
Interface :
Baudrate : 9600
Parity : 7-even-1stop
Handshake : Hardware
Interface settings
Data-protection : off
Theft-protection : off
Security settings
Key tone: on
Key settings
To Next Page
Loading...
