6 Determining moisture levels ■
45
Standard drying
The drying temperature is predefined by the user. The end
temperature is started up with a high heat output and is kept constant
with slight overshooting.
This program is used for most samples.
Boost drying
The drying temperature is predefined by the user. During the first
minutes of drying, the target temperature is exceeded by 40%. The
time is selectable between 0.1 - 99.9 min. Once this time has elapsed,
the temperature is adjusted down to the target temperature. The
temperature is started up with a high heat output.
The maximum temperature reached during the boost is the highest
definable temperature of the moisture analyser.
• HEATING PROGRAM
BOOST TIME 3.00 MIN Only if Boost is selected
HEAT MODE STANDARD
BOOST
SOFT
Select heating program
To Next Page
Loading...
