page 12
Diagram 5
Route the cable.
Route cable
through hole.
Diagram 4
4. Remove the shipping fasteners from the front panel. Diagram 4. With the
supplied hex key and a ½-inch box end wrench, loosen and remove the 4 bolts,
washers and nuts on the front panel. These fasteners are used during shipping to
hold the front plate in place. Discard the fasteners.
5. Remove any tape or wire ties securing the display cable to the side of the unit.
6. Route the display cable. Diagram 5. Unwrap the cable and remove any kinks.
Have an assistant hold the right upright support close to the base while you
route the cable through it.
Note: Attaching a string to the cable with a washer tied to the opposite end of the
string may help you route the cable through the upright support.
CAUTION: To avoid damage to the display
cable, read and follow these steps care-
fully. Damage to the cable due to improper
assembly is not covered by the Precor
limited warranty.
Remove the shipping
fasteners from the
front panel.
Front panel
The shipping
fasteners are found
on the right and left
sides of the front
panel.
Right side
mounting bracket
Right side upright
support
Display cable
Loosen the fasteners
with a hex key while
holding the nut with
a crescent or box
end wrench.
To Next Page
Loading...
