Precor 946i - Setting an Exercise Session Time Limit

Product Owner's Manual: Club Features 24
Setting an Exercise Session Time Limit
You can limit how long a user can exercise on the equipment. For
example, if you set the time limit to 20 minutes, users can only
enter a session time between 1 and 20 minutes.
Note:
You can also let a user exercise indefinitely by selecting
The automatic cool down period is appended to the end of
any time-based program, so adjust the time limit accordingly.
NO LIMIT.
However, you will need to instruct users that once they select a
program, they must press the TIME +/- key. A workout time blinks
in the display. They need to use the Number Keypad to type in
240, press the up arrow key to display NO LIMIT
The exercise session times available are between 1 and 240
minutes.
, and then press
OK.
Note: The Military Performance Programs will not complete if the
maximum exercise time limit is less than 40 minutes. Set the
maximum session time above 40 minutes if you have allowed users
to access these programs. Refer to Treadmill: Accessing
Performance Programs .
To set a maximum workout time:
1. At the SET MAX WORKOUT TIME prompt, press OK. Use the
navigational arrow keys to change the displayed time limit.
Note:
2. When you have selected a maximum workout time, press OK to
accept the displayed setting and move to the next feature.
When you press and hold a navigational arrow key, the
number increments by five, for example, 1, 5, 10, 15, 20. When
you tap an arrow key, the number increments by one.
Setting a Pause Time Limit
You can limit how long a user can pause while exercising on the
equipment by entering a time between 1 and 120 seconds (two
minutes). For example, if you set a pause time limit of 60 seconds,
the display automatically resets to the Precor banner if no
movement is detected and no key press occurs for one minute.
Important:
To set a maximum pause time:
The optional power adapter must be connected on
self-powered equipment to establish a definitive pause time limit.
If the optional power adapter is not attached and the rate of
motion drops below the minimum requirements, the equipment
begins its 30-second shutdown, effectively eliminating pause
mode.
1. At the SET MAX PAUSE TIME
2. Press OK to accept the displayed setting and move to the next
feature.
prompt, press OK. Use the
navigational arrow keys to select a time limit between 1 and 120
seconds (two minutes).