Precor 946i - Treadmill: Changing Remote Control Access; EFX: Changing the Auto-Level Setting

Product Owner's Manual: Club Features 27
Treadmill: Changing Remote Control
Access
Important:
When you enable this program, you can set a user’s speed and
incline through a computer software program that interfaces with
the CSAFE port on the treadmill.
To affect this setting, the treadmill must be connected
to a computer and you will need to be familiar with CSAFE
commands.
The default factory setting is set to DISABLED
1. At the
. To change this
setting, perform the following steps:
REMOTE SPEED CONTROL
Setting
prompt, press OK. Use
the navigational arrow keys to alternate between the two
selections.
Description
Lets you set the speed and incline for individual users
and their selected program using CSAFE commands
through a computer connection.
ENABLED
Disconnects remote access so you cannot use the
remote capabilities of a CSAFE connection. You
would also use this setting when the treadmill is not
connected to a computer.
DISABLED
2. When you are ready, press OK to accept the displayed setting
and move to the next program. For other options, refer to
the table in Accessing Club Programming Mode and Changing
the Settings .
EFX: Changing the Auto-Level Setting
You can set a specific ramp incline so that the EFX automatically
returns to it at the end of a workout session. Whatever incline you
set, the EFX ramp returns to the setting if a user continues
pedaling, once the program session has ended, and presses
RESET to return to the Precor banner.
Note: This setting is available on equipment with adjustable ramps.
Important:
1. At the
If you use this feature, connecting the optional power
adapter is recommended. Instruct users about the auto-leveling
feature and ask that they hold onto a stationary handrail with one
hand while the equipment automatically moves to the set incline.
SET CROSSRAMP AUTO-LEVEL
2.
prompt, press OK.
XRAMP n appears, where n is the ramp incline setting. Some
displays only show a number without prefacing it with XRAMP
3. When you are ready, press OK to accept the displayed setting
and move to the next feature. For other options, refer to
the
.
Use the navigational arrow keys to select the desired ramp
incline setting from 1 to 20.
table in Accessing Club Programming Mode and Changing
the Settings .