Erasing the Error Log
When you no longer need the error log information, you can erase
the entries.
To erase the error log entries:
1. Press QUICKSTART while any error description is scrolling
across the display.
2. Continue to maintain light pressure on the key until the
message HOLD TO CLEAR ERRORS
3. When you release Quickstart, the message
scrolls off the display.
NO ERRORS will
appear in the display if the error log has been deleted.
Important:
4. Press RESET to return to the Precor banner.
You cannot retrieve the error log once you have
deleted it. You may want to resolve any issues you are
experiencing with the equipment before erasing the error log.
User ID Entry with CSAFE Equipment
The equipment is fully compatible with CSAFE protocols. When
the equipment is connected to a CSAFE master device, the user is
prompted to press ENTER and begin an identification process.
The user ID is displayed as five zeros and indicates the starting
point. The following table describes key functions while in CSAFE
mode.
Table 8. CSAFE access keys
Keypad Description
Number keypad Use the number keys to enter a user ID. The number
that is pressed appears on the right. As the user
continues, the numbers fill in the display from right to
left. When all five numbers are in place, the user
must press ENTER or OK to submit the user ID.
CLEAR or
BACK
Erases individual numbers in the user ID from right to
left.
ENTER or OK Submits the user ID.
Note:
RESET or
PAUSE/RESET
User ID entry is bypassed when the user
enters five zeros. No workout statistics are recorded.
Resets the display to the banner.
A message appears on the display and indicates when the user ID
is accepted by the CSAFE master device. Once program selection
is complete, the user can begin exercising.
To review information about CSAFE specifications, visit the web
site at: www.fitlinxx.com/csafe
If you have questions or need technical support, refer to Obtaining
Service
.
To Next Page
Loading...
