Name: Precor C546i
Brand: Precor
Rating: 5 (1 reviews)

To Next Page

To Previous Page

C546i Self Powered Elliptical Fitness Crosstrainer

Page 49

9. Connect the replacement incline motor’s cable to the intermediate cable.

10. Mount the incline motor to the EFX frame with the clevis and hitch pins removed in step 2.

11. Calibrate the incline motor per Procedure 5.3.

12. Replace front and upper cover sections per Procedure 7.1.

13. Check the operation of the EFX as described in Section Four.

Section One - Things You Should Know3
General Information4
Tools Required4
Section Two - Preventive Maintenance5
Daily Maintenance5
Weekly Maintenance5
Quarterly Maintenance6
Procedure 3.1 - Software Access Codes7
Procedure 3.2 - Accessing the Diagnostic Program8
Procedure 3.3 - Displaying the Odometer10
Procedure 3.4 - Club Settings11
Procedure 3.5 - Documenting Software Problems12
Procedure 3.6 - Software Uploading Procedure13
Upload Procedure13
Procedure 5.1 - Measuring the Resistance of a Generator15
Procedure 5.2 - Inspecting and Adjusting Belt Tension17
Procedure 5.3 - Calibrating the Incline Motor20
Procedure 6.1 - Troubleshooting the Lower and Upper Interconnect Cables22
Procedure 6.2 - Troubleshooting the Keypad and Upper PCA24
Procedure 6.3 - Upper Display Does Not Illuminate26
Procedure 6.4 - Troubleshooting the Generator28
Procedure 6.5 - Troubleshooting Hand Held Heart Rate29
Procedure 6.6 - Troubleshooting the Incline System32
Procedure 7.1 - Replacing the Rear Covers34
Procedure 7.2 - Replacing the Lift Covers37
Procedure 7.3 - Replacing the Display Enclosure or Upper PCA40
Procedure 7.4 - Replacing the Lower PCA42
Procedure 7.5 - Replacing the Upper or Lower Interconnect Cables44
Procedure 7.6 - Replacing a Crankarm Assembly46
Procedure 7.7 - Replacing a Incline Motor48
Procedure 7.8 - Replacing the Input Pulley Belt50
Procedure 7.9 - Replacing the Generator Pulley Belt51
Procedure 7.10 - Replacing the Input Pulley Assembly53
Procedure 7.11 - Replacing the Step-Up Pulley Assembly55
Procedure 7.12 - Replacing a Stairarm Wheel56
Procedure 7.13 - Replacing a Stairarm Pedal58
Procedure 7.14 - Replacing a Stairarm59
Procedure 7.15 - Replacing a Ramp Assembly61
Procedure 7.16 - Replacing a Handlebar63
Procedure 7.17 - Replacing a Generator65
Procedure 7.19 - Replacing a Battery67
Procedure 7.20 - Replacing an External Power Input Jack69
Procedure 7.21 - Replacing the PROM70
Wiring Diagram 8.1 - C546I Self Powered71
Block Diagram 8.2 - C546I Self Powered72

Brand	Precor
Model	C546i
Category	Elliptical Trainer
Language	English

Precor C546i User Manual

Table of Contents

Questions and Answers:

Precor C546i Specifications

Related product manuals