Precor C546i - Procedure 7.14 - Replacing a Stairarm; Stairarm Replacement

C546i Self Powered Elliptical Fitness Crosstrainer
Page 59
Procedure 7.14 - Replacing a Stairarm
1. Remove the left and right side rear cover.
2. Remove the cover from the rear of the stairarm. The cover’s retaining screw is on the inside
and must be accessed from the opposite side of the EFX. Carefully, rotate the stairarm to a
position just forward of vertical to gain access to the cover’s retaining screw.
1. Remove the lift cover per Procedure 7.2.
2. Grasp the center ramp cover and lift it upwards to unsnap it from the ramp. Remove the
center ramp cover from the EFX and set it aside.
3. Remove the two screws that fasten the ramp end cap to the ramp. Remove the ramp end
cap. Refer to Diagram 7.11.
4. The left side and/or right side ramp trim will need to be removed in order to access the
stairarm wheels.
5. Loosen, but do not remove, the five screws that fasten ramp trim(s) required to access the
wheel(s) being replaced. Slide the ramp trim(s) off the front of the ramp.
Diagram 7.14 - Stairarm and Stairarm Connector
6. Remove the retaining ring that fastens the stairarm to the crankarm and remove the stairarm
from the EFX.
7. Remove the stairarm pedal per Procedure 7.13 and install it on the replacement stairarm.
Refer to Procedure 7.13.
Retaining
Ring
Stairarm