EasyManuals Logo

Precor C546i User Manual

Precor C546i
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
C546i Self Powered Elliptical Fitness Crosstrainer
Page 20
Procedure 5.3 - Calibrating the Incline Motor
1. Set the incline at its lowest position and remove the lift cover per Procedure 7.2.
1. Remove the four screws that retain the lower front portion of the front cover. Remove the
lower front cover
2. Grasp the center ramp cover and lift it to unsnap it from the ramp. Remove the cover.
3. Remove the two bolts that retain the incline motor yoke assembly in the ramp.
4. Carefully, slide the incline motor yoke out of the ramp and lower the ramp until it is resting
on the frame.
Diagram 5.4 - incline Motor Mounting and Calibration
5. Access the incline A/D reading via the Lift Test portion of the Diagnostic Program, see
Procedure 3.2.
6. With the A/D number displayed set it for a reading of 127 using the CROSSRAMP
and
CROSSRAMP
keys.
9-1/2”
Center
Ramp
Cover
incline Yoke

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Precor C546i and is the answer not in the manual?

Precor C546i Specifications

General IconGeneral
BrandPrecor
ModelC546i
CategoryElliptical Trainer
LanguageEnglish

Related product manuals