Precor EFX546 User Manual

page 27
COMMERCIAL PRODUCTS DIVISION
KEYS ON THE DISPLAY CONSOLE
The EFX has an easy-to-use keypad that is activated by the slightest touch. Remind
users that they only need to apply gentle pressure to these ultra-sensitive keys.
Each key on the display console’s keypad provides specific functions. Numeric keys
(numbered 1, 2, 3,... through 0) let the user enter data in answer to the display
prompts and change the ramp incline or resistance level during a workout. The
standard keys, Change, Reset, Cross Ramp ▲▼, QuickStart, Resistance ▼▲,
and Enter, let the user enter data as well as control his or her workout.
The following information explains the different uses of the keys from left to right.
To locate each key, look at the display console or refer to Diagram 16.
6
7
8
9
0
QUICK START
1
2
3
4
5
R
E
S
I
S
T
A
N
C
E
E
N
T
E
R
R
E
S
E
T
C
R
O
S
S
R
A
M
P
Diagram 16 Display console keypad.
Numeric keys: Indicates the
course number, time limit, weight,
or age. During a workout, use
these keys to select a target ramp
incline or resistance level.
Note: The CHANGE keys are shown in Diagram 15.
Gently, press and hold the ▼ or ▲ key
to change the resistance level.
During the Setup
prompts, accepts
displayed data and
moves to next
prompt.
Exits and
returns to
banner.
QuickStart: Bypasses the
remaining Setup prompts and
enters the Manual course.
Gently, press and hold the ▲ or ▼
key to change the ramp incline.
KEYPAD TIPS
• If the optional battery recharger is not connected, the user needs to maintain
a stride rate above 40 strides per minute before keypad entries can occur.
Refer to Informational Displays Prior to Shutdown on page 24.
• The Setup prompts need to be answered using the numeric keys or by press-
ing the ▼ or ▲ keys. Accurate entries are required or features such as
SmartRate
®
will not work properly.
• Pressing Enter selects the information being displayed.
• Pressing QuickStart bypasses further selections and prompts the user to
workout in Manual mode. Default values apply (see QUICKSTART on
page 29). The SmartRate
®
display does not appear.
• A time-out occurs during the Setup prompts if the EFX detects no key presses
for two minutes. The display returns to the Precor banner.
• Pressing Reset returns to the Precor banner.

Precor EFX546 Specifications

Mechanical Specifications

cross ramp angle	13 - 40 degrees (adjustable)
stride length	18 inches (46 cm)
resistance levels	1 - 20

Materials and Construction

frame	Powder-coated steel

Weight and Dimensions

length	80 inches (203 cm)
width	30 inches (76 cm)
height	62 inches (156 cm)
weight	230 lbs (105 kg)
shipping weight	340 lbs (155 kg)