Precor EFX546 User Manual

page 3
COMMERCIAL PRODUCTS DIVISION
• Keep all electrical components away from liquids to prevent shock. Do not
set anything on the casing, handrails, or display console. Place liquids
only in the appropriate receptacles.
• Never place your hand(s) or feet in the path of the roller arm because
injury may occur to you or damage may occur to the equipment.
• Never operate the unit if it is damaged, if it is not working properly, if it
has been dropped, or dropped in water. Return the unit to a service
center for examination and repair.
• Keep the optional battery recharger cord away from heated surfaces.
• Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
• Do not use outdoors.
• Do not attempt to service the EFX yourself other than the assembly and
maintenance instructions found in this manual. Refer to Obtaining Service .
HAZARDOUS MATERIALS AND PROPER DISPOSAL
The EFX546 has an internal battery which must be removed before the EFX is
scrapped. The battery contains materials which are considered hazardous to the
environment. Proper disposal of the battery is required by federal law.
To remove the battery from the EFX, take the following steps:
CAUTION: Unplug the battery recharger and disconnect it from
its receptacle at the rear of the EFX.
Tools required: Phillips head screwdriver and hex wrench set.
1. Remove both the right and left rear covers from the EFX.
2. Remove the top rear cover.
3. Unplug the black and red battery wires from the circuit board.
4. Separate the circuit board from the battery by removing four screws.
5. The battery is held in place with a metal bracket. Lift the battery away from
the bracket.
6. Dispose of the battery according to the federal Hazardous Waste Regulations.
SAFETY APPROVAL
When identified with the ETL-c logo, the EFX has been tested and conforms to
the requirements of CAN/CSA-E-335-1/3-94, Safety of Household and Similar
Electrical Appliances.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

Precor EFX546 Specifications

Mechanical Specifications

cross ramp angle	13 - 40 degrees (adjustable)
stride length	18 inches (46 cm)
resistance levels	1 - 20

Materials and Construction

frame	Powder-coated steel

Weight and Dimensions

length	80 inches (203 cm)
width	30 inches (76 cm)
height	62 inches (156 cm)
weight	230 lbs (105 kg)
shipping weight	340 lbs (155 kg)