S3.15 Assembly and Maintenance Guide
page 12
1 2 3 4 5 6
D. Slide a Plastic Washer and a Roller Pad onto one
end of a Roller Pad Rod. Insert one Mushroom
Cap to plug the end hole. If necessary, pound the
Mushroom Cap in place using the rubber mallet.
E. Insert the Roller Pad Rod through the hole in the
Leg Extension Arm.
F. Slide the remaining Plastic Washer and Roller Pad
on the other end of the Roller Pad Rod. Insert one
Mushroom Cap to plug the end hole. If necessary,
pound the Mushroom Cap in place using the
rubber mallet.
G. Attach the Floor Plate using
two ³⁄₄-inch buttonhead bolts
Wrench tighten using a 6mm hex key.
D
Roller Pad
Plastic Washer
E
Roller
Pad Rod
Mushroom Cap
F
G
2 - ³⁄₄" buttonhead bolts
Floor
Plate
Step 3. Install Seat and Rollers, continued
To Next Page
Loading...
