24 Installing and Operating the Personal Viewing System (PVS) for Display C
3. Feed the taped cables back up through the neck tube and
out the side hole. Continue to feed the taped cables down
through the upright support, following the same route as
the existing RJ45 cable.
Figure 12: Cable route through neck
4. Guide the taped cables straight down the upright and
then feed them through the small opening in the lower
boot and onto the floor.
Note: You may need to use needle nose pliers to gently
pull the cable connectors out the small opening.
Figure 13: Position of cables at base
To Next Page
Loading...