Beginning the Assembly 25
To replace the console and route the cables:
1. Grasp the cables at the top of the neck and pull them to
the left side.
2. Place the console on the neck of the equipment frame so
that the tabs on the back hook onto the bracket frame.
Figure 14: Location of tabs on console
3. Pull the cables up through the top of the console.
Figure 15: Cable Route through console
4. Reattach the display console by using the four buttonhead
screws removed previously, and wrench tighten.
Important: Make sure that the cables are not pinched
between the bracket and the display console.
5. Reattach the heart rate cable and the communication
cable.
To Next Page
Loading...