36 Installing and Operating the Personal Viewing System (PVS) for Display C
To install the new cables:
1. Feed the taped cables through the large, rectangular
opening at the top of the display console. Continue to
feed the taped cables down through the upright support,
following the same route as the existing RJ45 cable.
Note: Leave about 1 foot (30 cm) of cables hanging out of
the upper portion of the display console. The coaxial and
power connections will be attached to the back of the
screen.
Figure 34: Cable route through upright
2. Pull the taped cables out of the base of the upright
support and onto the floor.
CAUTION: Be careful as you slide the bracket into position
and align the mounting holes. Avoid sliding the bracket into
the STOP button housing as damage can occur to the
electronics board.
Figure 35: Cable position at base
To Next Page
Loading...