Beginning the Assembly 37
3. For the treadmill only, slide the screen mount down
through the frame of the treadmill. To attach the upper
part of the screen mount, use one washer with each
socket head screw. Partially tighten.
CAUTION: Avoid touching the heart rate cable or the heart
rate electronics board. Cable connections can become
dislodged which will impair the heart rate and upper display
functions.
Figure 36: Upper screen mount attachment
4. Place the locking tab against the bracket as shown in the
following figure:
Figure 37: Locking tab position on bracket
5. Line up the holes of the lower part of the screen mount
with the lower frame of the treadmill and slide the bracket
over the mount and frame.
Figure 38: Bracket position on assembly
To Next Page
Loading...