Beginning the Assembly 43
Installing the Headphone
To install the headphone jack:
1. Feed the audio cable through the break out in the display
console cover.
Figure 50: Audio cable path
2. Attach the ferrite clamp on the audio cable to the display
console near the headphone jack, being sure to allow
enough slack to attach the headphone jack.
Note: Ferrite not required for PEP assembly.
3. Replace the display console back cover by positioning one
side above the upright support fasteners. Pull in on the
other side to flex the cover which allows you to push it up
and slide it past the fasteners on the upright support.
Figure 51: Display console back cover replacement
To Next Page
Loading...