42 Installing and Operating the Personal Viewing System (PVS) for Display C
4. Fit the mounting bracket against the back of the PVS.
Move the cables to ensure they are not pinched. Secure
the PVS using four buttonhead screws. Torque to 19
inch-pounds using a 2.5 mm wrench.
Figure 48: Screen to bracket attachment
5. Plug the RJ45 cable into the back of the screen. Attach
the ferrite clamp on the RJ45 cable to the back of the
screen, near the base.
Note: Ferrite not required for PEP assembly.
6. Feed the coaxial cable between the back of the screen and
the bracket. Connect both the power and coaxial cables to
the proper receptacles. Turn the ends of the coaxial and
power connectors to properly secure the cables.
Figure 49: Cable connections
7. If you purchased the optional PEP feature, plug the RCA
cable into the RCA video connector on the back of the
PVS screen.
To Next Page
Loading...