PRESONUS ATOM SQ - Editor Modes

25
3 Advanced Studio One Integration
3.2 Screen Controls
ATOM SQ
Owner’s Manual
• Screen Encoder will select the next or previous item in the list
• Navigation arrows Up, Down, Left and Right will select the next or previous
item in the list (note that these arrows are different than the Page Left
and Page Right arrows which are directly below the Screen Encoder)
2. Channel Editor. Shows or hides the Effects’ interface, the Effects Editor.
3. Devices. When enabled and the Channel Editor is in focus, the Screen
Encoder selects the next or previous Effect in the Channel Editor.
4. Load Selected. Loads the currently selected Effect or Effect Preset onto
the selected track. This option will always be visible on the screen.
5. Close Folder. Either exits the current folder if available or
collapses a menu depending on the Tree mode being used for the
Browser. This option will always be visible on the screen.
6. Open Folder. Either dives into the next folder if available or
expands a menu depending on the Tree mode being used for the
Browser. This option will always be visible on the screen.
Note: Load Selected, Close Folder, and Open Folder will be available on the screen
whether these functions are possible or not.
3.2.3 Editor Modes
ATOM SQ’s Editor mode will change the screen to display commonly used functions
and commands for each of Studio One’s Editor windows (Audio, Pattern, and
Part). Note: Pressing the Editor button will open the respective editor type for
the currently selected Event(s) in the Editor Window. Pressing the Song or Inst
buttons will close the Editor window in Studio One and ATOM SQ’s screen will
change accordingly. The User buttons are also available while in Editor mode.
3.2.3.1 Pattern Editor
When the Pattern Editor is active, these controls will function as follows:
• Navigation Left and Right Arrows. Bank to the next or previous 16
steps (if available). Holding down Shift + either Navigation Left or Right
will select the next or previous Pattern Event in the Arrangement.
• Navigation Up and Down Arrows. Select the next or previous
lane for programming (tapping a pad in the upper lane will also
select the pad’s respective lane in the Pattern Editor).
• Plus (+). Use the Plus (+) to add an accent to a step. Press and
hold +, then tap a pad in the lower lane to add an accent.
• Minus (-). Use the Minus (-) button to add a tie across multiple steps. Press
and hold -, then tap a pad in the lower lane where the note should start
and tap a step later in the pattern where you want the note to end.