PRESONUS STUDIOLIVE 24.4.2 - Internal FX Send Controls

3939
Owner’s Manual
Quick Start:
Level
Setting
OverviewHookupConnecting
to a
Computer
TutorialsTechnical
Information
Trouble-
shooting
and Warranty
Scenes, Presets, System Menu,
and MIDI Control
Software: Universal Control,
SL Remote, Capture,
and Studio One Artist
Controls 4
Controls
39
Aux and FX Buses 4.4
4.4.2 Internal FX Send Controls
Mute Button Mutes and Unmutes the Internal Effects Bus.
This button will mute or unmute its internal eects (EFX) bus. It will illuminate red
when the bus is muted.
Post Fader Send Button Enables and Disables Post Fader Send.
By default, this button is enabled, and the send levels to the eects buses are
post-EQ, post-dynamics processing, and post-fader and therefore are aected by
fader settings. If the button is disabled, by default, the EFX sends use the Pre 2
setting, in which the sends are post-EQ and post-dynamics but pre-fader. However, in
the System Menu, you can switch the EFX sends to the Pre 1 setting, in which the
sends are pre-fader and pre-Fat Channel dynamics processing and EQ. Please review
Section 5.4 for details.
Output Level Control Adjusts the Master Level of the Effects Send.
This knob controls the overall output level of the internal eects mix.
Internal Eects Send
Select Button
Enables Fat Channel Viewing.
As described in section 4.1.1, the Select button routes its Eects bus through the Fat
Channel, allowing you to add dynamics processing and EQ. From the Fat Channel,
you can also route each Eects bus to the Subgroups or Mains. By default, both FXA
and FXB are routed to the Main bus.
Mix Button Enables Aux Bus Mixing and Metering in the Fat Channel.
When this button is enabled, the 24 encoders in the Fat Channel become the fx-send
level controls for each of their respective input channels. The meters will display the
send level of each of the input channels.