In order to use the EAGLE with this configuration, insert 2 M6 screws (a) in each PLUS ring (2 screws for each ring) and so
fix the EAGLE. If you want to use a guide scope in parallel, you can install the PLUS guide rings. In order to do this, screw 2
M5 screws for each guide ring in the upper part of EAGLE (b).
Connecting to telescopes provided with PLUS support rings and support rings spaced more than 12cm.
If you want to use EAGLE with telescopes equipped with rings PLUS spaced more than 12cm, you can place EAGLE over to
the support ring for supporting a compact guide scope in parallel. But to do so you first need to add a PLUS Vixen or Lo-
smandy style dovetail bar above PLUS support rings and then connect EAGLE (image 19).
In order to use the EAGLE with this configuration, use a PLUS Vixen or Losmandy style dovetail bar (with the same length
as the one used under the support rings) and fix it with two M6 screws (c) for each ring. The dovetail bar above the tele-
scope must be fixed in inverted position with respect to the one placed below the optical tube. Then use 4 M6 screws (d)
to fix the EAGLE to the dovetail bar. Finally if you want to use a guide scope in parallel , you can install the PLUS guide
rings. In order to do this, screw 2 M5 screws for each guide ring in the upper part of EAGLE (e).
To Next Page
Loading...