DS600 Non-Ferrous Double Sheet Detector
This document is confidential and proprietary. No part of this document may be disclosed in any manner
to a third party without the prior written consent of Prime Controls, Inc.
202177 i Revision M
Revision History
Revision Date Description Author
G 2017-01-23 Change bracket part number from BR30AN to BR30PL,
added Aluminum distance graph and ranges.
RMC
H 2017-01-31 Added Stainless Steel distance graph and ranges. RMC
I 2017-02-20 Added ModBus physical and electrical characteristics. RMC
J 2017-12-21 General clean up and clarification. V1.07 software release. RMC
K 2019-02-12 Corrected error in LTol default value. V1.10 software release
and SW8 reference to Modbus termination. Added wire
colors to Table 8. Corrected company address.
RMC
L 2019-03-13 V1.11 software release. Corrected operation of Modbus
Read Multiple Registers command (FN06). Increased
tolerance for Probe Disconnect detection. Calibrate
algorithm enhancement. Reject output off during device turn
on.
RMC
M 2020-01-14 Added recommended Htol settings for single point
calibration on aluminum and 300 series stainless steel.
JAM
To Next Page
Loading...
